Old Town Leander is the grid of streets around US 183 and Bagdad Road that the Austin and Northwestern Railroad surveyed in 1882, when the line bypassed the older town of Bagdad a mile west and Bagdad's post office, stores, and families moved over to the tracks. The 1893 school here grew into the largest district in Williamson County. For a century Old Town was the whole town, and it is still where the library, the fire administration on Sonny Drive, and the rail station sit.
The housing is the most mixed in Leander: a few early 1900s cottages on piers, 1950s and 1960s ranch homes on the first slabs, 1990s infill, and 2010s Craftsman-style builds by the national builders on the last open lots. That means galvanized pipe, copper, and PEX on the same block, and crawl spaces next to slabs.
Your call reaches an independent local water damage provider serving Old Town Leander by phone. The provider figures out what the house is built on before deciding anything.
A 1960s ranch house with a warm spot in the hall and a spinning meter is a leak detection call with copper under the slab as the usual answer. A cottage on piers with water under the floor after a stalled storm is water extraction that starts in the crawl space. A 2015 infill two-story with a stained ceiling under the attic is ceiling water damage repair.
The Leander Public Library anchors the civic end of Old Town, and the CapMetro Red Line ends a few blocks away at Leander Station, the northern terminus of the ten-station commuter line to downtown Austin, with 600 parking spaces and the new Northline district going up beside it.
Call (737) 317-2602 and describe what you found. We route the call to an independent local water damage provider serving Old Town Leander.
Standing water pulled off the slab, the upstairs subfloor, and the garage in a Leander two-story, with meter readings taken before anything is cut.
Dehumidifiers and air movers sized for a humid Hill Country summer, run until the drywall, the stair treads, and the cabinets read dry.
A high Leander water bill, a warm tile, or a soft wall traced to a PEX fitting, a slab line, or a manifold before anyone opens the floor.
Ceilings, walls, and floors soaked when an attic or exterior wall line split in a freeze, pumped out and dried once the valve is closed.
Creek water and street runoff pulled out of a garage or ground floor, contaminated materials removed, and the house dried afterward.
An attic or garage tank that let go, and the ceiling, insulation, closet, and flooring it soaked on the way down, dried and opened only where wet.
A stain or sag under an upstairs bath, an attic air handler, or a drain pan, metered from above before the drywall comes down.
Wet insulation, ceilings, and walls dried out after Hill Country hail or a stalled spring storm found a gap in the shingles or flashing.